This product is a USB 2.0 micro converter for performing RS-232C serial communications with external devices. Each converter has one channel RS-232C serial port. You can use the standard COM driver software (COM Setup Disk) supplied with the converter to access the serial ports as standard Windows COM ports. To use this micro converter, you must install the appropriate CONTEC driver software.
Certification
CE
Environmental
RoHS Directive
Features
- Conforming to the USB 2.0 and USB 1.1 standards
- Uses the same easy-to-use D-SUB 9 pin connectors as a PC. The converter has a D-SUB 9 pin connector (female), allowing you to directly connect it to a device such as a modem. You can also connect it to a cable having a D-SUB 9 pin connector (female) through the bundled gender changer. (* The gender changer is attached before shipment.)
- Maximum communication speed = 921,600bps. This converter is equipped with separate 128-byte and 384-byte buffers for transmit and receive.
- Driver software is supplied to allow the serial ports to be used as standard Windows COM ports.(They can be set to arbitrary COM port numbers.) A maximum of 127 terminals can be installed as configured in the range COM1 to COM256.
- The communication lines for each channel are electrically isolated from each other and from the PC. Surge protection is provided for each RS-232C signal line.
Specification
Communication
Isolation Isolation and surge-protection
Transmission system RS-232C (Async.)
Transmission speed 300 -- 921,600bps
Page Top
Options
Product Code |
Product |
CN5-D9F |
9pin D-SUB (Female) Connector Five-piece Set |
CN5-D9M |
9pin D-SUB (Male) Connector Five-piece Set |
RSC-25F/9F |
Cross Cable for Connector Conversion, RS-232C(25F -> 9F, 1.8m) |
RSC-9F |
Cross Cable, RS-232C D-SUB9P(1.8m) |
RSS-25M/9F |
Straight cable for Connector Conversion, RS-232C(25M -> 9F, 1.8m) |
RSS-9M/F |
Straight Cable, RS-232C D-SUB9P(1.8m) | |